Amonite necklace

1 Metre Tiger Tail
3 packets S shaped connectors (60 pieces)
1 strand 4mm beads (63 beads)
4 x 10mm crimp connectors
Crimp beads
2 wire connectors
Suede cord

Cut 2 x 14cm pieces of 10mm thick suede cord. Onto each end crimp your flat leather connector using a pair flat nose pliers.



Cut a 50cm length of tiger tail. Place 2 crimp beads onto the end, followed by your wire protector, before you crimp the crimps, place one of your suede pieces onto the centre of your protector. Pinch the ends of your wire protector together and take your tiger tail back through the crimps and flatten them onto wire to secure.


**String 1 S-shaped connector, 1 x 4mm bead, 1 S-shaped connector until you have 20 connectors strung. String 3 4mm beads** String from ** to ** again, then add a further 20 connectors before crimping the other side of your suede .




The Connectors are now linked together.

Onto the tiger tail string 1 x 4mm bead, 1 crimp, 1 x 4mm bead, 1 crimp, 1 x 4mm bead. Take the tiger tail through all 20 connectors on a section, then pass back through the 4mm, crimp 4mm, crimp, 4mm. Pull tightly together and flatten the crimps against the wire. Cut off your tail and finish the other 2 sections as before.


To complete your necklace we simply add 1 jump ring on either side, before you close on side add your lobster clasp.