Chains, Pins and Connectors
chains, pins, and connectors |
| You Will need: |
|
Eyes Pins
Chain
Small Beads
Large Beads
|
Using eye pins make up seven sections with 1 crystal / 1 lamp work bead / 1 crystal. They should look like this:
Cut off ten links of your chain. Try using a head or eye pin to make counting easier, then sut into the 11th link. Cut off 9 sections. Slightly open one end of your eye pin and slip the chain onto your ready made section. Link together your bead and chain sections to form section below x 2.
Your 7th section is linked to both sides of your chain. Open an 8mm jump ring, remembering to twist open rather than pull open, this way the sections will fit back together again neatly. Pass through both sides of your chain sections, then insert your beaded section onto the ring as well.
The remaining sections of chain are added into the bottom of 7th beaded section. To complete your project measure enough of your chain to allow linked sections to fit over your head, join onto both sides of beaded section using the last eye.
|
| |
|
|
